![]() ![]() ![]() Before beginning the reprogramming procedure, remove any old flash reprogrammingįiles from the DRBIII memory. Then follow the directions on the DRBIII emulator. NOTE: If this flash process is interrupted/aborted, the flash should be restarted and Then turn the KEY to the RUN position and Press Page Forward to ![]() The flash of the PCM Turn the Key to the OFF position and disconnect theīCM. The BCM will need to be disconnected after the module When flashing a 2002 – 2004 LH vehicle the BCM may need to beĭisconnected if experiencing failures during the flash of the transmission The module can only be reprogrammed to a more Selected and programmed, the controller cannot be reprogrammed to aĭifferent calibration. A Diagnostic Trouble Code (DTC) will beĬAUTION: Extreme care must be taken when programming a calibration into a Will not operate the engine until it is programmed. Replacement ofįuture PCMs will require programming utilizing the DRBIII and TechCONNECT. Modules will no longer be pre-programmed when received from Mopar®. Mopar® is currently phasing out pre-programmed PCMs for the vehicles listed. I have flash DVD for the DRB III, hopefully I will get it and can then do programming on a “swap” system. Look here: Procedure in detail will be of interest to those contempating a PCM changeĪfter reading this, it is obvious that PCMs can be reprogrammed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |